Pin Mapping for Orange Pi 4 LTS for ADXL345 - General Discussion - Klipper
I am using an Orange Pi 4 LTS to run Klipper, and I am trying to connect my ADXL345 which was previously connected to a Rpi3B. It has a 23 pin header instead of 40- is this possible? These are the two pinout diagrams, but I cannot find an Rpi mapping, nor make sense of the names enough to convert. Any help is appreciated!
PDF) Development of a Low-Cost Vibration Measurement System for
PDF) Development of a Low-Cost Vibration Measurement System for
Is it possible to connect adxl345 to orangepi 3 lts? : r/OrangePI
Orange Pi 3 LTS ADXL345 : r/klippers
Orange Pi 3 LTS ADXL345 : r/klippers
ADXL345 Raspberry pi4 multi SPI - General Discussion - Klipper
ADXL345 Raspberry pi4 multi SPI - General Discussion - Klipper
ADXL345 - Klipper Tuning
Orange Pi 3 LTS ADXL345 : r/klippers
PDF) Development of a Low-Cost Vibration Measurement System for